DO7033
• Never use the device with a defective comb attachment, because such an attachment
could have sharp edges. There is a risk of injury!
To guarantee perfect operation:
• Always operate the device only according to the information on the rating plate in
order to allow optimal function.
• Do not subject the hair/beard trimmer to temperatures less than +10° C or greater
than +40° C.
• Clean the device thoroughly after each use. • This device is not intended to be used
by persons (including children) with restricted physical, sensory or mental capabilities
or a lack of experience and/or lack of knowledge, unless they are supervised by a
person responsible for safety or receive instructions from that person on how the
device is to be used.
BEFORE USE
The hair/beard trimmer can be used as a cordless or mains device.
Operation with the mains adapter:
First plug the mains adapter cable plug into the device, and then connect the mains
adapter to the power supply system (230 V ~). A charging level display (CHARGE)
lights up. The hair/ beard trimmer is ready for immediate use in mains operation.
CHARGING THE BATTERIES AND CORDLESS OPERATION:
• Make certain that the device is switched off.
Before the first use, you should charge the batteries of the hair/beard trimmer for at
least 16 hours.
For subsequent charges, a charging time of approximately 8 hours is sufficient.
Fully charged batteries allow cordless use for approximately 50 minutes.
• Place the device into the charging station.
• Plug the mains adapter cable into the connection on the back of the charging station.
• Connect the mains adapter to a suitable socket with earth contact (230 V ~).
The LED charging level indicators (CHARGE) on the device light, one after the
other, and indicate the charging process.
The charging level display , which is equipped with light-emitting diodes (LEDs), is
located on the front of the device. It shows the current charging status.
The LEDs light blue, one after the other, starting with 20%. The other LEDs also
light constantly as soon as the respective charging level has been reached.When the
rechargeable batteries have been fully charged, all LEDs light at the same time.
When only the lowest LED (20%) lights, you should charge the batteries fully again as
soon as possible.
If you are using your hair/beard trimmer and it comes to a standstill because of low
batteries, you can continue trimming by plugging it into the wall power supply.
The hair/beard trimmer is equipped with two Ni-MH heavy duty rechargeable batteries
with overcharge protection.
It can be recharged without power restrictions; there is no risk of an overcharge.
19
