Lindy 38258, User Manual

Page: 4 / 20

User Manual English
2. LCM: Displays the status of each input and output plus options available when in Menu mode.
3. Lock Button & LED: Press this button to lock all the function buttons on the panel, press and
hold it again to unlock the buttons. The LED will illuminate red when the buttons are locked.
4. Return: Press this button while in Menu mode and you will be taken back a step.
5. Menu: Press this button to enter the Menu:
1. EDID:
a. Standard EDID: use the built in EDID which supports video up to 1080p@60Hz /
WUXGA@60RB and Audio LPCM 2CH.
b. Dynamic EDID: Copies the first connected output device EDID.
c. Manual EDID: Uses the EDID of each device connected to the input / output ports.
2. IP:
a. IP address
b. Netmask
c. Gateway
3. Temperature:
a. Temperature 1
b. Temperature 2, shows the internal temperature of the device.
4. LCM Contrast range from 1-4
6. Left/Right Arrows: Use these buttons to scroll through the pages while in the menu mode.
7. Save: Press this button to save the current setting of the Input / output ports (8 positions
available).
8. Recall: This button will allow you to recall the saved pre-sets.
9. Enter: Press this button to confirm the setting or selection.
10. All: Press all, then the input port then enter to display the same signal on all ports.
11. Out/In: Use these buttons to select the input source you want to show on an output/display.
The sequence should be to select the output ports (display) from the top row of buttons, then
select the input source device.
12. 1-8: The numbers relate to the input and output ports on the rear of the unit.
Rear Panel
Note: the example below shows an 8x8 matrix fitted with HDMI input and HDMI output boards.
1. Output 1-8: Connect your display devices to the output ports.
2. Central CPU Board: (with the following connections)
a. IR In: Extend your IR receiver port using the included IR receiver.