User Manual
English
6.
On the
8 Port Splitter/Transmitter
set the other EDID selection switch
STD/TV
to
TV
to
use the TVs EDID. In this case the EDID will be read from the first display recognised
starting at output port 1. (Any DVI EDID may be ignored.) If this causes problems to any
of the displays connected or if you want to limit colour depth to 8 Bit switch to the
STD
setting: 1080p 8/12 Bit and PCM 2CH Audio.
The 8 Port Splitter/Transmitter provides an HDMI SYNC LED showing the status:
Orange: 3D signal; Red: 2D signal; Off: no sync, check signal cable.
7.
Connect The TX or 8 Port Splitter/Transmitter to your HDMI source.
8.
Repeat all steps until all HDMI displays are connected.
9.
Once all cables are connected, power on all devices starting from the Display(s) and
ending at the HDMI source.
10.
If you are having problems with some of your displays or if you want to reduce the colour
depth to 8 bit switch the EDID selector to 8 bit and STD: 1080p 8/12 bit and PCM 2CH
Audio.
Trouble Shooting
CAT6 cable distances are supported up to 40 meters at 1080p/8-bit resolution and 15 meters at
1080p/12-bit resolution provided a high quality HDMI signal is provided by the HDMI source and
high quality S/FTP Cat.6 (or higher) shielded RJ45 cables are used. For a more detailed listing
see the table above in section Features.
If you cannot reach long distances try higher quality or shorter cables to isolate the
problem or use a more stable HDMI signal source.
The single Transmitter TX module especially in combination with the Extender EX
module may not be able to support Cat.6 cable distances up to 40m if the HDMI source
signal is not stable. In this case replace the single TX by an EX module and switch its
input to HDMI port.
If you are using more than 2 layers of cascaded extenders the maximum cable lengths in
the final layer to the RX may be reduced by 10m.
Please check if all power LEDs are lit. Replace the power supply
Please check if all cable connections are seated well.