Barrier Systems by Lindsay
+1 (888) 800-3691 (U.S. toll free or +1 (402) 829-6800 - ECN 60881
Barrier Systems by Lindsay
+1 (888) 800-3691 (U.S. toll free or +1 (402) 829-6800 - ECN 60881
8
INSTALLATION AND MAINTENANCE MANUAL
Figure 9: Install the hinge covers by first dropping the rod located
on the inside bottom of the cover in the slots located on each of the
hinge bases. Rotate the cover up to the closed position and install
the two keeper pins through the top.
Figure 10: The hinge covers will stay upright and opened after the
cover is installed as instructed above.
Figure 11: Rotate the cover up to the closed position and install the
two keeper pins through the top as shown below.
The barrier section is now ready to be lowered on to the
ground and put into service. Depending on how the section
was raised, either activate the Air Control Panel to lower the
section or hand jack the section back to the down position.
CAUTION: Keep feet clear from the edge of the section
when lowering.
NOTE: For proper operation all hinge pins and hinge
covers must be installed and each section must be FULLY
lowered so that the section rests on the ground and not
on the wheels
.
Moving Barrier with a Vehicle
BSI manufactures a truck mounted barrier push roller
adapter assembly that can be easily attached to a
standard pickup. Using a vehicle, large sections of
barrier can be moved quickly and safely.
Figure 12. The push rollers move the barrier sections without
causing damage.
Figure 13. To deploy a barrier wall that is stored against a curb,
move the end of the barrier out so that the truck can gain access.
Slot
Slot