MINI COMPRESSOR
9
NOTE:
If the defect persists even after the above steps are taken, contact a service centre.
15. TABLE OF MALFUNCTIONS
Malfunction
Cause
Removal
compressor does not run switch is in the off position
check the switch (2.)
regulation set to minimum
adjust pressure setting using the adjusting screw (3.)
power cable is not plugged
in the socket properly
unplug the cable from the socket and replug it
issue with the socket
try connecting a different device to the socket
compressor runs but
does not achieve the set
pressure
leaky joints, air hose con-
nected incorrectly
unplug and replug the air hose in accordance with
point 11. (How to Work with Speed Fittings)
Do not forget to specify the following:
• type of defect
• product type
• production year
• product's serial number (found on the machine plate)
14. PUTTING INTO OPERATION
1. Interconnect the air supply and beverage supply.
2. Connect the mini compressor to the power mains.
3. Check that all the joints and connections are sufficiently tight.
4. Turn on the air compressor using the switch and pressurise to the desired pressure.
WARNING:
Use the device only as an accessory to flow-through coolers. Follow the safety
instructions and do not overload the device.
LINDR 15
for pressurising a single beverage line with maximum flow rate of
40 l/h
.
LINDR 30
for pressurising two beverage lines with maximum flow rate of
120 l/h
.
Summary of Contents for VK 15
Page 12: ......
