Transponder
All keys of this specific block are now deleted !
Delete all transponder keys of an individual relay or block:
The individual transponder key is now deleted!
Put DIP of the
specific block or
relay (1/2/3) to ON
Press reset button
on the logic board
> 5 sec
Set all DIP to
OFF
Program 2
Deleting transponder keys
Delete specific keys:
LED flashes
(2x long)
Put DIP of the
taught-in key
to ON
Put the desired
key to the
reader
Set all DIP to
OFF
Keypad
Programming
instructions
Please read first - then do the programming!!!
Before programming your Cody Universal 3 with your personal codes, please check the faultless
function of the appliance with the help of the factory‘s pass code 1234 and the button.
Usually, any programming is made via your personal mastercode. In order to get familiar with that kind
of programming, you start with the input of a new pass code, which replaces the one preset by the
factory (1234). The procedure is explained under item “Program 2“.
After that please change the factory set mastercode to your personal code of choice.
Attention / Note
In case you made a mistake on programming, you can start over again by pushing the
button
Factory setting = 1-8
Program 1
Input of a new mastercode
Enter 8 digit
mastercode
The new mastercode is now saved!
Sound signal
2x long
push
button
push
button
Sound signal
1x long
Enter 8 digit
NEW
mastercode
button
push
