Your personal code does not replace the permanent code that the
dealership gave you. You can use either code to unlock your vehicle. If a
second personal code is entered, the module will erase the first personal
code in favor of the new code.
If you wish to erase your personal code, use the following instructions:
1. Enter factory set code.
2. Press 1/2 control and release.
The system will now only respond to the factory set code.
Anti-scan feature
If the wrong code has been entered 7 times (35 consecutive button
presses), the keypad is disabled for one minute and the keypad lamp will
flash during this time.
Note:
Pressing 7
•
8 and the 9
•
0 simultaneously
during this one minute period will still lock the vehicle.
The anti-scan feature will turn off after one minute of keypad inactivity.
Unlocking and locking the doors, liftgate and liftgate window using
keyless entry
To unlock the driver’s door,
enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate,
press the 3
•
4 control within five
seconds.
To open the liftgate window,
press the 5
•
6 control within five
seconds.
To lock all doors, liftgate and liftgate window,
press the 7
•
8 and
the 9
•
0 at the same time.
Note:
The driver’s door must be closed. You
do not
need to enter the keypad code first.
Activating/deactivating autolock with the keyless entry system
1. Turn the ignition to the OFF position.
2. Close all the doors, the liftgate and liftgate window.
3. Enter 5–digit entry code
4. Press and hold the 7
•
8. While holding the 7
•
8 press the 3
•
4.
5. Release the 3
•
4.
6. Release the 7
•
8.
The user should receive a
horn chirp
to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
2004 Navigator
(nav)
Owners Guide (post-2002-fmt)
USA English
(fus)
Locks and Security
165
