Page 8 of 16
User Manual
Operation Instructions
Subject to modifications
4.1EN-10004-A08
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Start-up
Filling of Reservoir
If the reservoir is positioned vertically and the oil level is at or
below the minimum marking, you have to refill oil.
6042c07
Fig. 4
Oil-level check in the reservoir
6001a02
IMPORTANT
CHAIN OIL ONLY!
Observe paragraph "Suitable Oils" in
chapter "Technical Data".
Make sure that the reservoir is filled with oil and is posi-
tioned vertically.
Should the oil level be too low, open the reservoir cover 8
(Fig. 5).
Refill clean oil through filter insert 9.
Close the reservoir cover again in order to avoid contami-
nation inside the reservoir.
Fig. 5
Filling of the 5-liter reservoir
6494c05
8 -
Reservoir cover
9 -
Filter insert
Filling of Line System
The filling of lubrication lines with lengths over 0.5 m in
the installed system proceeds very slowly due to the
pump elements. The filling time can be reduced by filling
the lines directly with an oil gun or oil injection device.
Block both ends of the filled feed line by hand so that no
oil can penetrate.
Reconnect the feed line between its original ports again.
Repeat this procedure for each empty feed line.
