Part Number 4607056 Rev 0 6/21 15
Step 2
NOTE: Notch (In Top)
to Rear of Unit.
1/4-20
Lockwasher
and 1/4-20
x 1/2 Hex
Head Bolt
TOP
Top Unit
1. Remove door, conveyor and finger assemblies.
2. Turn unit on left side, as shown.
3. Drill holes in cover, as shown. Refer to Step 3 in “For
4. Assemble top of bottom unit to bottom of top unit with
4 bolts, as shown.
Step 3
Stacking Units
1. Position top unit over top of bottom unit and align top
flanges with bottom unit.
2. Replace 4 screws, as shown (2 in front, 2 in rear).
3. Replace door, conveyor and finger assemblies.
4. Stacking is complete.
FOR TRIPLE OVEN
Step 1
1. Remove door, conveyor and finger assemblies.
2. Turn unit on side, as shown.
3. Remove three screws from Front Cover.
4. Fasten base to oven with four 1/2 - 13 x 1/2
"
long Hex
Head Bolts. Be sure to align the holes at the front of the
oven and stand first.
NOTE: The front edge of the stand should line up with the
front edge of the oven.
5. Screw casters into base.
Step 2
1. Set oven upright.
2. Remove oven top by removing 2 screws in front and 2
screws in back.
(Save the screws.)
3. Replace door, conveyor and fingers.
Step 3
TOP
From Bottom Unit
7/8
DRILL 5/16 Dia.
(4) Holes
3-1/4
1. Prepare top for mounting as shown above.
