Lincoln Cobra 501, Owner'S Manual

Page: 12 / 20

6.3A-68002-A01
Page 12 of 20
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Owner’s Manual
Cobra 501
S
u
b
je
c
t
to
m
o
d
if
ic
a
ti
o
n
s
Setting of the height position
Set the height position by means of the 8 nuts M in such way
that:
1. the mouth piece A is on the same height as the
lubrication nipple during the whole carriage runway.
2. the fixing plates B are aligned parallelly to the center
line of the rollers to be lubricated; i.e. normally align
the fixing plates B horizontally by means of a water level.
Note:
The measures S1 and S2 are the same and factory-set;
Control and adjustment only after maintenance or repair
works.
The fixing nuts have to be secured
against unintentional working loose.
Regarding chains respectively belts with only small fluctuations
in height of the lubrication nipples (less than 1.5mm), the
COBRA can be directly attached to the 4 long holes of the base
plate G by means of 4 threaded rods and 8 nuts M 20.
The fixing plates B and the corresponding fixing and resiliency
material can be omitted.
The setting of the height position is to be effected as described.
Fig. 7: Setting of height
4318a01