Page Number - 3
Form 422589
REEL INSTALLATION AND ADJUSTMENT
See Figure (3). The guide arm may be positioned in 22-1/2
degree increments as shown. For ease of operation and
increased hose life, the guide arm should be positioned to
minimize hose strain as the delivery hose is pulled through
the roller outlet.
Three studs must be used to securely attach the guide arm. It
may be necessary to change the position of the hex head
screw and one stud in order to obtain the desired guide arm
position.
The hose clamp must be relocated if the guide arm is in
position B or C. Refer to SERVICE PARTS for hose clamp
location.
SAFETY INFORMATION
Read and understand all warnings, cautions and instructions
before operating this equipment. Extreme caution should be
used when operating this equipment as personal injury and/
or property damage can result from equipment misuse.
Adequate personal protection is recommended to prevent
splashing of material on the skin or in the eyes. ALWAYS
disconnect air coupler from pump when the pump is not
being used.
PRESSURE RELIEF PROCEDURE
Always perform this procedure when the pump is shut off and
before checking, servicing, installing, cleaning or repairing
any part of this system.
Perform the following procedure:
A. Disconnect the air supply to the pump.
B. Point the dispensing valve away from yourself and
others.
C. Open the dispensing valve into an appropriate container
until the pressure is relieved.
If the above procedure does not relieve the pressure, the
dispensing valve or hose may be restricted. To relieve the
pressure, very slowly loosen the hose end coupling. Then
loosen completely and clear the dispensing valve and/or
hose.
INSPECTION
Prior to operation or maintenance a visual inspection shall be
made. Check reel system for leaks, worn or missing parts.
Any reel that appears to be damaged in any way, is badly
worn or operates abnormally shall be removed from use until
repairs are made. Contact factory authorized service center
for repairs.
If overpressurizing of the equipment is believed to have
occurred, contact a factory authorized service center for
inspection of the reel.
Annual inspection by a factory authorized service center is
recommended.
DISASSEMBLY
To disassemble, perform ASSEMBLY procedures in reverse.
To order call 1-800-548-1191 or visit www.partdeal.com - [email protected]