Displaying the Factory Set Code
Note:
You will need to have two programmed intelligent access keys for
this procedure.
To display the factory-set code in the information display:
1. Place the first programmed key in the
backup slot inside the center console. The
key ring must be at the top with the buttons
facing toward the rear.
2. Press the
START/STOP
button once and
wait a few seconds.
3. Press the
START/STOP
button again and
remove the key.
4. Insert the second programmed key into the backup slot, then press
the
START/STOP
button.
The factory-set code will appear in the information display for a few
seconds.
Note:
The code may not display until after any other warning messages
first display.
TRUNK RELEASE
From Inside Your Vehicle
Press the button located on the instrument panel.
74
Locks
2014 MKS
(mks)
Owners Guide gf, 1st Printing, April 2013
USA
(fus)