Note:
You can activate and deactivate the driver and front passenger
Belt-Minder independently. When deactivating or activating one seating
position, do not buckle the other position as this will terminate the
process.
Read Steps 1 - 5 thoroughly before proceeding with the programming
procedure.
Note:
If you are using MyKey, you cannot disable Belt-Minder. Also, if
the Belt-Minder has been previously disabled, it will be re-enabled during
the use of MyKey. See the
MyKey
chapter.
You can activate and deactivate this feature by performing the following
procedure:
Before following the procedure, make sure that:
•
the parking brake is set.
•
the transmission selector lever is in position
P
.
•
the ignition is off.
•
the driver and front passenger safety belts are unbuckled.
1. Switch the ignition on. Do not start the engine.
2. Wait until the safety belt warning light turns off (about one minute).
3. Wait 10 seconds after the safety belt warning light turns off.
•
Step 4 must be completed within 20 seconds after the completion of
Step 3.
4. Buckle then unbuckle the safety belt three times at a moderate speed,
ending in the unbuckled state.
•
After Step 4, the safety belt warning light will turn on for three
seconds.
5. Within about seven seconds of the light turning off, buckle then
unbuckle the safety belt. The safety belt warning light will blink.
•
This will disable the Belt-Minder feature for that seating position if it
is currently enabled.
•
This will enable the Belt-Minder feature for that seating position if it is
currently disabled.
Safety Belts
41
2014 MKS
(mks)
Owners Guide gf, 1st Printing, April 2013
USA
(fus)