Tips for setting codes:
•
Do not set a code that uses five of the same number.
•
Do not use five numbers in sequential order.
Erasing personal codes
1. Enter the factory set 5–digit code. The keyless entry keypad and
interior lights will illuminate and the driver’s door will unlock.
2. Press and release the 1
•
2 within five seconds of completing Step 1.
3. Press and hold the 1
•
2 for two seconds to erase the customer
programmed codes.
All personal codes are now erased and only the factory set 5–digit code
will work.
Note:
To exit programming mode, either wait 5 seconds after pressing 1
•
2 on the keypad, or press the 7
•
8 and 9
•
0 pads simultaneously to
lock all vehicle doors and end programming mode.
Unlocking and locking the doors using keyless entry keypad
To unlock the driver’s door,
enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other.
Note:
The driver’s door will unlock and the interior lamps will
illuminate after the factory set 5-digit code or your personal code are
correctly entered.
To unlock all doors,
press the 3
•
4 control within five seconds.
To lock all doors,
press the 7
•
8 and the 9
•
0 at the same time. You
do not
need to enter the keypad code first.
Note:
The interior lamps
will turn off. If the driver’s door is ajar, the doors will not lock.
Releasing the trunk with the keyless entry system
To release/open the trunk, enter the factory-set code or personal code
(driver door unlocks) and press 5
•
6 within five seconds.
If your vehicle is equipped with the optional power decklid, pressing 5
•
6 again will close it (you may need to reenter the keypad code again).
Before operating the power decklid, be sure that no one,
particularly a child, is in a position where he or she can be
injured by the trunk lid. NEVER leave the remote entry transmitter
where it can be inadvertently activated, as someone could be seriously
injured by a moving decklid.
2008 Town Car
(tow)
Owners Guide (post-2002-fmt)
USA
(fus)
Locks and Security
80
