Low beam
•
Disconnect electrical connector
and remove retainer and
headlamp bulb from headlamp
assembly.
High beam
•
Remove the bulb by turning it
counterclockwise and then pulling
it straight out.
•
Disconnect the electrical
connector from the bulb.
Handle a halogen headlamp bulb carefully and keep out of
children’s reach. Grasp the bulb only by its plastic base and do
not touch the glass. The oil from your hand could cause the bulb to
break the next time the headlamps are operated.
5. To complete installation, follow the removal procedure in reverse
order.
Note:
To ensure a good seal, attach the bulb cover and partially tighten
the screws. Check to ensure the gasket is fully centered. Finish
tightening the screws in a criss-cross pattern (upper-left, lower right
etc.)
Replacing HID low beam headlamp bulbs (if equipped)
The low beam headlamps on your vehicle use a “high intensity discharge”
source. These lamps operate at a high voltage. When the bulb is burned
out, the bulb and starter capsule assembly must be replaced by your
authorized dealer.
2008 Town Car
(tow)
Owners Guide (post-2002-fmt)
USA
(fus)
Lights
35
