2
Headlamps
Rotate the headlamp control clockwise to the second position to
turn on the headlamps. Pull the headlamp control towards you to
turn on the foglamps. Must be in autolamp mode, parklamp
position or headlamp position for foglamps to operate. Rotate
the control counterclockwise to initiate the autolamps. (This light-
sensitive system turns your exterior lamps on and off automatically.
It also keeps the lights on for approximately 20 seconds after the
ignition switch is turned to the OFF position.) To turn the system off,
rotate the control clockwise to the OFF position.
3
ABS Light
Your anti-lock braking system (ABS) detects the onset of wheel lockup
during brake applications and helps prevent wheels from locking
during extreme braking situations. The ABS warning light will
illuminate when you start your engine; however, if it stays on,
continues to flash or fails to illuminate, see your dealership's service
department immediately.
5
Speed Control
You must be traveling at or above 30 miles per hour to use the
speed control system. Press ON to enable speed control. Press
SET + to set a speed. To set a higher speed, accelerate to the
desired speed, press and release SET +. To establish a lower
speed, press and hold the SET - control until you get to the desired
speed, then release the control or depress the brake pedal or
press CNCL until the desired vehicle speed is reached then press
the SET + control. To return to a previously set speed, press RES.
To disengage speed control and erase the previously programmed
set speed, press OFF.
6
Audio System
Please see Audio System on the reverse side of this guide.
7
Climate Control
Please see Climate Control on the reverse side of this guide.
4
Service Engine Soon
This light will illuminate briefly when you start your vehicle to ensure
that the engine warning system is functional. If it comes on after the
engine is started, one of your engine’s emission control systems
may be malfunctioning. Or, it may stay on because your vehicle is out
of fuel, existing fuel quality is poor, or the fuel cap hasn’t been
properly tightened. If you have added high quality fuel or tightened
the fuel cap and the light continues to stay on, remember that it can
take three driving cycles for the light to turn off. (A driving cycle
consists of a cold engine startup followed by mixed city/highway
driving.) No additional vehicle service would be required.
