Lincoln Electric WELDLINE PROTIG NG S 10 Instructions For Safety, Use And Maintenance Download Page 1

Page: 1 / 40

www.weldline.eu

LINCOLN ELECTRIC EUROPE S.L.

c/o Balmes, 89 - 8

- 08008 Barcelona - SPAIN

WTT2

20W

18W

Curent

Duty cycle 60%

250 A

350 A

Duty cycle 100%

200 A

320 A

Light alloy welding, reduce the duty cycle about 30%
Water fl ow mini

1.0 l/mn

Water pressure

3.3 bars

Maxi temperature inlet water

45°C

Voltage class

L - 113 V

Gas fl ow

Mini : 7 l/mn - Maxi : 13 l/mn

Using electrodes

Ø 1.0 / 3.2 mm

Ø 1.0 / 4.0 mm

Origin

equipment fi tted

to the torch

Back Cap

Long

Nozzle

Ø 12 mm

Electrode

Ø 2.4 L

WTT2

4 m

8 m

20W

RL S

W000278893

W000278906

18W

RL S

W000278897

W000278900

20W

RL C5B

W000278894

W000278905

C5B

18W

RL C5B

W000278898

W000278899

N°8695-1196_Rev2_05/2018

We thank you for your trust in our company by purchasing this equipment which will provide
you with complete satisfaction if you comply with its conditions for use and maintenance.

CAUTION:

The company declines all responsibility in case of modifi cation, addition of

components or subassemblies, or any transformation of the equipment carried out by
the customer or a thirdparty, without prior specifi c written agreement from the company.

Arc welding and plasma cutting may be dangerous for the operator and persons close
to the work area. Read the operating manual and safety instructions W000261712.
See www.weldline.eu.

A) Maintenance / Troubleshooting

Before any internal verifi cations and repair work, make sure that the equipment is separated
from the electric installation by electrical isolation (by electrical isolation is meant a group of
operations designed to separate and keep the equipment de-energized).
At least every six months, you must check the proper condition of the insulation and
connections of the electric equipment and accessories such as plugs, fl exible wires, ducts,
connectors, extension leads, partholders, electrode-holders, or torches...
Maintenance and repair work on the jackets and insulating ducts must be carried out
extremely carefully.
Have defective parts repaired by a specialist, or better still, have them replaced.
Routinely check the proper tightening and cleanliness of the electric connections.

B) Work-station

Use only electrode holders and torches which are perfectly insulated.
The operator must be insulated from the ground-surface and the workpiece (gloves, safety
shoes, dry clothes, leather apron, and so forth...).
Do not touch the electrode wire and the part (or the nozzle) simultaneously.

C) Protection

It is absolutely essential that your protect your eyes from blinding glare (glare of arc invisible
light and infrared and ultraviolet radiation).
The welding mask, without or with helmet, must always be equipped with a protective fi lter
whose gradation depends on the welding arc current intensity (EN 169 Standard).
Fumes emitted during welding operations may be dangerous. Use adequate protection
means (fumes extraction, ventiled masks...)

Technical data

TIG manual torch with natural cooling

Safety instructions

French lever range

Ergonomic Range

WTT2

4 m

8 m

20W EB S

W000278891 W000278911

18W EB S

W000278895 W000278902