Lincoln Electric SPEEDTEC 215C, Operator'S Manual

Page: 10 / 23

English 8 English
1. Left Knob: The value of parameter in the upper left
side of display [2] is adjusted.
2. Display: Parameters of welding process are shown.
3. User Button (left): Button function could be set:

Advanced menu:

Recalls advanced menu (default)

Recalls user memory.

Inductance.

Run-in WFS.

Burnback.

Basic menu – changes basic menu for advanced
menu.
4. EURO Socket: For connecting a welding gun (for
GMAW / FCAW-SS process).
5. Positive Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
6. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
7. Power Switch ON/OFF (I/O): Controls the input
power to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the
power switch is turned on, the indicator will light up
to indicate the machine is ready to weld.
8. Escape Button (right):

Cancels an action / exit menu.

Locks and unlocks knobs and buttons on the
panel (press and hold button for 4 seconds).
9. Set Knob: Type of welding procedure and welding
settings is changed by this knob.
10. Right Knob: The value of parameter in the upper
right side of display [2] is adjusted.
Figure 2
11. Gas Connector: Connection for gas line
12. Power Lead with Plug (3m): Power lead with plug is
a standard equipment. Connect the power lead with
plug to the main supply before turning power on.
Figure 3
13. Wire Spool Support: Maximum 15kg spools.
Accepts plastic, steel and fiber spools onto 51mm
spindle.
14. Spooled Wire (for GMAW / FCAW-SS): The
machine does not include a spooled wire.
15. Welding Wire (for GMAW / FCAW-SS).
16. Terminal Block of Changing Polarity (for GMAW /
FCAW-SS process): This terminal block enables to
set the welding polarity (+ ; -), which will be given at
the welding holder.
17. Shield of Changing Polarity.
18. Wire Drive (for GMAW, FCAW-SS process): 2-Roll
wire drive.
19. Work Lead.
20. Thermal Circuit Breaker (25A): The power source
features a resettable 25A thermal breaker. If the
current conducted through the breaker exceeds 25A
for an extended period of time, the breaker will open
and require manual reset
WARNING
Positive (+) polarity is set at the factory.
WARNING
Before welding check the polarity for using electrodes
and wires.