MAINTENANCE
4.
Insert a new untrimmed liner into the connector
end of the cable. Be sure the liner bushing is
stencilled appropriately for the wire size being
used.
Note: For liners KP1950-7, KP1950-8, KP1955-1
and KP1599-2
Before fully seating the liner bushing, it will be neces-
sary to trim the liner’s inner tube flush with the liner
bushing using a sharp blade. After trimming, remove
any burrs from inner tube and insure that the opening
is fully open.
5.
Fully seat the liner bushing into the connector.
tighten the set screw on the brass cable con-
nector. The gas diffuser, at this time, should not
be installed onto the end of the gun tube.
6.
With the gas diffuser still removed from the gun
tube, be sure the cable is straight, and then trim
the liner to the length shown in Figure D.1.
Remove any burrs from the end of the liner.
7.
Screw the gas diffuser onto the end of the gun
tube and securely tighten. Be sure the gas dif-
fuser is correct for the liner being used. (See
table and diffuser stencil.)
8.
Tighten the set screw in the side of the gas dif-
fuser against the cable liner using a 5/64" (2.0
mm) Allen wrench.