SOLUTION
Clean or replace front
cover lens.
Clean the Auto-Darkening
cartridge with soapy water
solution and soft cloth.
Clean or replace front
cover lens.
Check for cracked or pit-
ted front cover lens and
replace as required.
Make sure you are not
blocking the sensors or
solar panels with your
arm or other obstacle
while welding. Adjust your
position so that the sen-
sors can see the weld arc.
Replace front cover lens
as needed.
POSSIBLE CAUSE
Front cover lens dirty.
Cartridge dirty.
Front cover lens dirty.
Front cover lens is dam-
aged.
Sensors are blocked or
Solar panel is blocked.
Missing, damaged,
broken, cracked or
distorted front cover
lens
TROUBLE SHOOTING GUIDE
Test your shade cartridge prior to welding by directing the front of the car-
tridge toward a bright source of light, then using your fingers rapidly cover
and uncover the sensors. The cartridge should darken momentarily as the
sensor is exposed. A torch striker can also be used.
6
PROBLEM
Difficult to see through
filter.
Filter does not darken
when arc is struck.
ADF is
cracked.
Weld spatter
is damaging
the filter.
WARNING
Cease (STOP) using this product if this prob-
lem exists. UV/IR protection may be compro-
mised resulting in burns to the eyes and skin.
PARTS LIST
WARRANTY INFORMATION
WARRANTY INFORMATION:
These helmets are warranted for a period of one year. Please
contact us at
1 (866) 236-0044
for any service or warranty questions.
SPATTER DAMAGE IS NOT COVERED BY WARRANTY:
Do not use this product without the correct protective clear cover lenses installed properly on
both sides of the Auto-Darkening Filter cartridge (ADF). The cover lenses supplied with this hel-
met are properly sized to work with this product and substitutions from other suppliers should be
avoided
7
1
1
2
ITEM
1
2
PART No.
KP3323-1
KP3324-1
DESCRIPTION
INSIDE AND OUTSIDE COVER LENS
HEADGEAR ASSEMBLY
2345 Murphy Blvd. Gainesville, GA 30504 TEL: 866-236-0044
