C. Selecting Welding Parameter
Description:
The following options can be regulated using the
Select
button and the procedure below: 2/4 Step Trigger, Burnback,
Run-In, Crater, Hot/Soft Start, Pre-Flow and Post-Flow.
Press
SELECT
button
KNOB 1:
Turn Right (
) or Left (
)
KNOB 2:
Turn Right(
) or Left (
)
Trigger Mode
2 strokes / 4 strokes
Default Value: 2 strokes
2 strokes: Keep trigger pushed during
welding. See crater sequence below.
4 strokes: You can release the trigger while
welding. See Hot/Soft start and crater
sequence below.
Burnback
0 to 1 second by step of 0,05s
Default Value: 0,1s
Keeps the arc ignited for a short time while
the wire stops. Prevents the wire from
sticking in the weld puddle.
Run in
% of WFS (Wire Feed Speed)
Default Value: 60%
Speed of the wire before arc ignition.
Pre-flow
0 to 2,5 seconds by steps of 0,5 s
Default Value: 0 s
Post-flow
0 to 10 seconds by steps of 0,5 s
Default Value: 2 s
Crater Duration (sec)
0 to 5 sec
Allows to set lower or higher welding
parameters to improve the bead shape at the
end of the weld.
NO
YES
4 Strokes
4 Strokes
Crater WFS
Welding WFS (m/min)
Crater Voltage
Welding Voltage (Volts)
Hot/Soft Start WFS
Allows to set higher or lower welding
parameters to improve the bead shape at the
start of the weld.
In 4 strokes mode only: The Hot/Soft Start
sequence starts when the arc is ignited and
will stop when the trigger is released. Then
the weld starts with the main welding
parameters.
Hot/Soft
Start ?
NO
YES
Welding Voltage (Volts)
Hot/Soft Start Voltage
Welding WFS (m/min)
Improve the protection of the bead before arc
ignition.
Improve the protection of the bead after arc
extinction.
Crater ?
2 strokes: The crater sequence starts when
the trigger is released and stops when the
crater duration is over.
4 Strokes: The crater sequence starts on the
third action of the trigger and will last until the
trigger is released. When the trigger is
released, the arc stops.
Hot/Soft Start is available only in
4 strokes mode.
2
2 Strokes
Release the "SELECT" button to exit this menu on any step.
Innershield V350PRO
YES or NO
Improves Innershield welding performance
with V350PRO generator.
Innershield
YES or NO
Improves Innershield welding performance.
English
English
6
