A-15
INSTALLATION
LF-72
A-15
INSTALLING ELECTRODE
CONDUIT KITS
ELECTRIC SHOCK can kill.
• Turn the input power OFF at the dis-
connect switch before working on
this equipment.
• Do not touch electrically hot parts.
---------------------------------------------
Electrode conduit is used when feeding wire drums,
from boxes or large reels. For best feeding results,
use the shortest conduit length possible and avoid
sharp bends.
(For Codes 11209-11211 and above)
To install Lincoln conduit: (See Figure A.10b)
1. Turn off power at the welding power source.
2. Remove the “O” ring holding the ball bushing
assembly to the back of the wire feeder. Remove
the ball bushing assembly.
FIGURE A.10b
3. Place a K1546-xx conduit connector into the back
of the wire drive. Rotate the conduit connector to
a position where the thumb screw does not inter-
fere with the idle arm or door.
4. Tighten the set screw to secure the conduit con-
nector in the wire drive.
5. Insert conduit through the sheet metal of the LF-72
and into the conduit connector. Secure with the
thumb screw.
FIGURE A.11
WARNING
