Lincoln Electric K2803, Operator'S Manual

Page: 16 / 34

English English 13
TANDEM ARC (2-ARC) SYSTEM CHECKLIST (See Tandem Arc Connection Diagram)

Place Power Wave
®
AC/DC 1000 SD CE units in suitable operating location.
 Mount MAXsa™ 10 Controllers.
 Install MAXsa™ 22 Wire Drives and other accessories in their operating location.
 Connect a K1785-xx Wire Feeder Control Cable (14 pin) between the two power sources (top connectors).
 Connect K2683-xx Heavy Duty ArcLink Control Cables (5 pin) between Power Wave units and MAXsa™ 10
controllers.
 Connect K1785-xx Wire Feeder Control Cable (14 pin) between the MAXsa™ 10 controllers and the MAXsa™ 22
feeders.
 Install Electrode Sense Lead (67) at each feeder and the Work Sense Lead (21) from the Lead Power Wave
®
AC/DC 1000 SD CE Master per guidelines.
 Connect / Install welding cables per recommended "Output Cable Guidelines" ." (see Table1: Output Cable
Guidelines)
 Open the Power Wave
®
AC/DC 1000 SD CE front panels and configure DIP switch settings per the decal on the
panel. (see Figure #2: Dip Switch Settings) .

Connect input power to Power Wave
®
AC/DC 1000 SD CE units per recommended guidelines.
 Turn on Power Wave
®
AC/DC 1000 SD CE and verify all system Status Lights are solid green.
 Confirm that the latest software is updated in all equipment prior to installation (www.powerwavesoftware.com).
 Run the subarc cell configurator from PC Tools (see section accessories of this manual or go to
www.powerwavesoftware.com).
 Select a Welding process and configure starting and ending options.