INPUT VOLTAGE RECONNECT
PROCEDURE
When received directly from the factory, units are con-
nected for, 460 VAC. If 460 VAC is the desired input,
then the machine may be connected to the power sys-
tem without any setup required inside the reconnect
door. For other voltages refer to the instructions locat-
ed on the Reconnect Panel Access Door or follow the
instructions below.
Failure to follow these instructions can cause
immediate failure of components within the
welder.
------------------------------------------------------------------------
1. Open the access door on the left side of the
machine.
2. For 208-230: Position the large switch to 208-230.
For 380-575: Position the large switch to 380-575.
3. Move the “A” lead to the appropriate terminal.
Refer to figure A.1 below.
THE
LINCOLN
ELECTR
IC CO.
CLEVELAND,
OH
IO
U.S.A.
..
..Do not touch electrically live parts.
Only qualified persons should install,
use or service this equipment.
RECONNECT PROCEDURE
1.
BE
SURE
POWER
SW
ITCH
IS OFF.
208V
220-230V
380-415V
440-460V
575V
'A'
INPUT
VOLTAGE
RANGE.
removed.
Do not operate with wraparound
inspecting or servicing machine.
Disconnect input power before
IF MACHINE CEASES TO OPERATE
(NO METER, NO FAN)
2.
CONNECT
LEAD
'A'
TO
DES
IRED
3.
POS
ITION
SW
ITCH
TO
DES
IRED
INPUT
VOLTAGE
RANGE.
S21230-
AND THERE IS NO OTHER KNOWN FAILURE: CHECK FUSE;
VOLTAGE=380-575V
VOLTAGE=208-230V
REPLACE WITH SPECIFIED FUSE.
A
THE LINCOLN ELECTRIC CO. CLEVELAND, OHIO U.S.A.
.
.
.
.
Do not touch electrically live parts.
Only qualified persons should install,
use or service this equipment.
RECONNECT PROCEDURE
1. BE SURE POWER SWITCH IS OFF.
208V
220-230V
380-415V
440-460V
575V
'A'
INPUT VOLTAGE RANGE.
removed.
Do not operate with wraparound
inspecting or servicing machine.
Disconnect input power before
IF MACHINE CEASES TO OPERATE (NO METER, NO FAN)
2. CONNECT LEAD 'A' TO DESIRED
3. POSITION SWITCH TO DESIRED INPUT VOLTAGE RANGE.
S21230-
AND THERE IS NO OTHER KNOWN FAILURE: CHECK FUSE;
VOLTAGE=380-575V
VOLTAGE=208-230V
REPLACE WITH SPECIFIED FUSE.
A
Figure A.1 Input Voltage Reconnect Instructions
CAUTION
INSTALLATION
INVERTEC
®
V276
A-3
Summary of Contents for INVERTEC V276
Page 29: ...NOTES INVERTEC V276...
Page 30: ...NOTES INVERTEC V276...
