B-8
OPERATION
B-8
Rev. 13
INVERTEC
®
CC400-T/TP
5
、
Action
At idle, before
welding
Voltage Current
Press Sel
button
0
1
.
is used to set the relationship between the pre-
set current value and the external analog signal(0-10V)
from the 6-Pin connector. When it is set to 1, the pre-set
current value would increase with the external analog
signal increased, the reciprocal relationship would be
chose
when it’s set to 0. We suggest that you would set
to 0 when remote control box or foot switch control is
used. The factory setting is 0.
6
、
Action
At idle, before
welding
Voltage Current
Press Sel
button
0
1
.
The parameter is used to enable (1) or disable (0)
switching 2-level welding currents on the torch trigger in
lift TIG or HF TIG modes. Set to 1, enable this function,
the preset base current will be the second welding current
(the percentage of peak current). The welding torch
trigger is closed and released quickly in the third step, the
welding current will be switched to second current value;
and then if the trigger is closed and released again
quickly, the welding current will be switched to the preset
peak current; and then if the trigger is closed consistently,
the welding will get into crater current. This function is
only available in non-pulse and 4-step modes. Factory
default setting is 0.
Error Codes:
If an error occurs below, output will be disabled
immediately and will restore normal state after error
solved.
Error code table
301
Relay faulty
The pre-charge phase is over, and the relay
is not on.
302
Overcurrent protection
The machine is overcurrent.
303
Over/under voltage protection
Line voltage too high or low
304
No water-cooling protection
No water in the water-cooling mode
Restore Factury Setting
Enter restore factury setting
1
、
Action
At idle, before
welding
Voltage Current
Press recall
buttton
1
10
2
、
Action
At idle, before
welding
Voltage Current
Press
Mode+Crater
+
11
3
、
Press successive two times
，
then restorng
factory setting finishes.