English 13 English
Memories
Welding process and all parameters which belongs to
cycle can be saved in a memory slot in order to be
recalled after.
“Memories” menu is accessible for both process TIG and
Stick process from “Home menu”.
Figure 20
Push the right button to access to memories menu.
Figure 21
1. On the top of memory page, the current settings
which are going to be saved are displayed.
2. With the knob it is possible to scroll up or down to
select an empty or used slot memory. If the slot is
already used, the parameters associated to the
backup are displayed.
Push the knob button to recall the process and
corresponding parameters stored in the selected slot.
3. In order to save the current setting in memory, push
the right button and keep it hold until the end of
saving.
Figure 22
If button is released before the end of saving process, slot
will not be erased.
Guided Setup
Guide Setup is a feature for SMAW which configures
automatically the power source according to a set of input
data:
Type of metal sheet.
Type
of
electrode.
Electrode
diameter;
Based on this data, the power source will be automatically
configured to get the most suitable parameter for the
configuration.
Guide Setup activation
Guided Setup can be activated in “
System Option
” then
“
Weld Mode Setup”
.
In “Manual Mode”, assistance is deactivated. A push on
knob button will allow to activate it
Guide Setup use
When Guided mode is activated, Home page will be
adjusted by:
Adding list of all inputs data in “Primary Settings”
section.
Preset a defined current value.
Modifying current range ribbon
Primary settings:
To change and configure input parameters press the knob
button and navigate to parameter desired. Then push
knob button to validate.
Once parameters are modified, the output welding current
will be automatically adjust to fit with the application.
1
2
3
