IS392 ECN4127
Page 10
CLEANING
Disconnect the unit from the electricity supply. Use a mild detergent in hot
water and a soft cloth. Do not use abrasive creams or scourers.
Slide the doors to the middle position; lift up and out of the runners to remove.
Remove the shelf by lifting at the back edge and lowering off the supports to a
diagonal position.
Remove the side glass panels by unscrewing the black plastic fastener and
carefully lift the glass from the channel.
Remove the fan diverters.
The shelf may be washed in a dishwasher.
MAINTENANCE
Regular cleaning of the unit is recommended. No other regular maintenance is
required, but it may be necessary to clean the condenser or replace a light tube.
CLEANING THE CONDENSER
Disconnect the unit from the electricity supply.
The condenser is located behind the rear panel, remove the screws holding this
panel in place and remove the panel to expose the condenser. Use a vacuum
cleaner to remove any debris from the face of the condenser. Replace
the panel and refit all of the screws.
REPLACING THE LIGHT TUBE
Disconnect the unit from the electricity supply.
Remove doors. Unclip the end caps from the light unit. Remove the diffuser
from its clips. To remove the tube, carefully rotate it 90
o
and slowly pull down
until it is released. It is recommended that the starter (a round cylinder
located at one end of the tube) is also replaced at the same time. To
remove the starter, rotate it anticlockwise. Fitting the new tube is the
reverse of the above sequence.
