IS397 ECN 3694
11
Hotplate
1.
Remove the control knobs and fascia panel, by firstly removing fixing screws.
2.
Protect the surrounding area panel work with soft material and support the fascia panel
against it. Access to the hotplate switches is now possible. Remove completely the
component screws from the fascia.
3.
Unscrew the heat deflector. Access to the hotplate restraining nuts is now possible through the
fascia.
4.
Remove the hotplate restraining nut and press the underside of the hotplate up to facilitate
easy removal from above. Protect the surrounding panel work with soft material. Support the
hotplate and access to the hotplate connection block is now possible. Number the wires with
an indelible pen to facilitate replacement.
5.
Replacement is a reversal of the removal procedure, taking care not to trap the wiring harness.
6.
Check the unit for electrical safety.
Oven Fans
1.
Ensure that the electrical supply is disconnected.
2.
Remove the oven shelves.
3.
Loosen the fan guard screws and lift off the keyhole slots.
4.
Remove the hex head nut from the centre of the fan, this is a left-hand thread, and remove the
fan blade.
5.
Working from the back of the unit, remove the rear cover panel.
6.
Remove the electrical connections from the relevant motor.
7.
Remove the three securing screws and extract the motor unit.
8.
Refitting is the reversal of removal.
9.
Check the unit for electrical safety.
Contactor
1.
Ensure that the electrical supply is disconnected.
2.
Working from the back of the unit, remove the rear cover.
3.
Remove the electrical connections from the contactor.
4.
Release the clip from the base of the contactor.
5.
Refitting is the reversal of removal.
6.
Check the unit for electrical safety.
Over Temperature Cut-Out Thermostat
1.
Ensure that the electrical supply is disconnected.
2.
Remove the thermostat bulb from the top of the oven.
3.
Working from the back of the unit, remove the rear cover panel.
4.
Remove the electrical connections from the thermostat housing.
5.
Remove the front control panel A.
6.
Pull the thermostat bulb through the oven back.
7.
Remove the two securing screws and remove the thermostat unit.
8.
Refitting is the reversal of removal.
9.
Check the unit for electrical safety.
