IS397 ECN 3694
10
External Cleaning
Do not use abrasives on stainless steel or enamelled parts.
Do not use any products containing chlorine or hydrochloric acid to clean stainless steel
surfaces.
Do not clean the appliance using a water jet.
COMPONENT REPLACEMENT
Hotplate Switch
1.
Remove the control knobs and fascia panel, by firstly removing fixing screws .
2.
Protect the surrounding area panel work with soft material and support the fascia panel
against it. Access to the hotplate switches is now possible. Remove completely the
component screws from the fascia.
3.
Remove and replace wires correctly, ideally transferring wires across, from the old switch to
the new, one at a time. Numbering each wire with an indelible pen may also help.
4.
Replacement is a reversal of the removal sequence. Be careful not to trap the wiring harness
whilst replacing the fascia and check the wiring is still protected where it passes through the
heat deflector.
CONTROL
KNOB
FASCIA
HOTPLATE
ELEMENT
FASCIA
FIXING
SCREW
FASCIA
FIXING
SCREW
HEAT
DEFLECTOR
Thermostat
1.
Follow the procedure as for replacing Hotplate Switches above.
2.
Unscrew the heat deflector.
3.
Unclip the thermostat phial and remove the thermostat completely, keep the insulating sleeve
to use on the new thermostat.
4.
When replacing the new thermostat ensure that the insulation is secured in place and that the
routing is secure to prevent shorting internally with any switch gear.
5.
Replacement is a reversal of the removal sequence. Be careful not to trap the wiring harness
whilst replacing fascia.
