Page 11 of 23
Max. 15 mm
DL1
motor housing
Installation for the DL1A system
The aluminium motor housing is supplied with six M6 threaded holes for mounting on the desk frame.
1. Mount the motor housing on the top frame using six M6 screws with the following specifications:
Quality: Min. grade 8.8
Length: Max. 15 mm (plus top frame thickness). The screw must not go further than max. 15 mm into the motor housing
2. Fasten the screws thoroughly (torque: max. 7.5 Nm).
Always use six M6 screws for mounting the motor housing on the top frame
The mounting screws must not go further than max. 15 mm into the motor housing
Sufficient stability of the desk is only obtained if all six M6 screws are used for mounting the motor housing on the top
frame.
LINAK recommends using the DESKLINE
®
DL1A system in push applications with the motor housing mounted upwards.
