Page 10 of 24
Tabletop
Absorbing
material
Height of the DL1 in the lowest position
Min. desk height
Floor level
Mounting guidelines for the DESKLINE DL1A
Figure 2
Figure 1
The lifting units are normally mounted with the motor housings upwards and pointing towards each other
(see figure 2).
The aluminium motor housing is supplied with 6 pcs. of M6 threaded holes meant for mounting on the desk frame.
The threaded holes are rolled into the aluminium housing.
It is recommended to use all 6 M6 threaded holes. As the tabletop amplifies the sound we advise you to place a
vibration/shockabsorbing material between the tabletop and the table frame.
A suitable desk height in the lowest position can be obtained by mounting the lifting unit on a 6-8 mm bottom plate by means
of 4 pcs. of M6 countersinked screws. We recommend you to use screws of min. quality 8.8. The thrust moment must not
exceed 10 Nm in the bottom plate thread.
Max. 15 mm
DL1
motor housing
