LIMIT LIDD266, Instruction Manual

Page: 15 / 27

ATTACHEMENT
1. Components that could be transferred from one side to the other directly after disassembling are
listed below:
c p a c d n e p o t r o o d p o t – overslip (2pcs)
– top cover buckle (1pc)
t f a h s e g n i h – sleeve (1 or 2pcs)
– screws of top hinge (3 pcs)
)c p 1 ( yl b m e s s a e g n i h e l d d i m –
)s c p 2 ( e g n i h e l d d i m f o s w e rc s –
t r e s n i – nail (2 pcs)
)s c p 2 ( p a c w e rc s –
)c p 1 ( r e p p o ts r o o d –
)c p 1 ( yl b m e s s a e g n i h m o tt o b –
)s c p 3 ( e g n i h r e w o l f o s w e rc s –
2. The component that could be swapped over from one side to the other only after reconstruction
is listed below:
– top hinge assembly
3. Components that could be swapped over from one side to the other in pairs are listed below:
– adjustable foot with internal thread (used with the lower hinge)
–
4. Components that could not be reused temporarily are listed below :
– left fridge door stop
p o ts r o o d e g d ir f t h g ir –
Note :
Ensure the Appliance is unplugged and empty.
Adjust the two leveling feet to their highest position.
We recommend you have someone to assist you.
.
You should rest the Appliance on something solid e.g. a chair just below the top panel.
.
Maintenance
FRIDGE DEFROSTING
The fridge defrosting process is carried out automatically every time the compressor stops.
The defrost water is automatically routed to the drain port and into a tray placed on the top of the
compressor to the rear of the appliance from which it evaporates.
Make sure the drain port on the fridge at the rear of the appliance is kept clear.
FREEZER DEFROSTING
Frost will accumulate inside the freezer depending upon the length of time during which the door is
left open or the amount of moisture introduced.
.
This might allow air to penetrate the cabinet, thus encouraging continuous running of the compressor.
Thin frost formation is quite soft and can be removed with a brush or plastic scraper. Do not use metal
or sharp scrapers, mechanical devices or other means to accelerate the defrosting process. Remove all
.
.
For the removal of heavy ice deposits disconnect the appliance from the mains supply and empty
the contents into cardboard boxes and wrap in thick blankets or layers of paper to keep them cold.
as quickly as possible.
An increase in temperature of frozen food packages during defrosting will shorten the storage life.
Provided that the contents are well wrapped and placed in a cool area, they should keep for several hours.
Examine the contents when replacing them in the freezer and if some of the packages have thawed out.
soda and then dry thoroughly. Wash all removable parts in the same way and reassemble.
Reconnect the appliance to the mains supply and leave for 2 to 3 hours on setting number MAX
before introducing the food back into the freezer and setting the thermostat to your normal setting.
13 12