Limerick PJ's Bliss, Owner'S Manual

Page: 30 / 36

Troubleshooting
Your PJ's Comfort
®
and PJ's Bliss™ breast pump are designed for ease of use, effectiveness and
safety. Our high standards are the result of our certified lactation consultants’ experience
with thousands of mothers expressing milk for their infants. If you have any questions about
the use or assembly of your
PJ's breast pump:
✓
Check the instructions on pages 18-21 and /or go to www.limerickinc.com to make sure
you have assembled the accessory kit properly.
Problem Instruction
A Not turning on, no lights at all Indication of a Possible Power Adapter Failure
1 Insure adapter power jack is inserted fully and
dosent feel to be loose.
2 Unplug the power adater completely from the
pump and wall outlet, inspect the cords for any
signs of damage.
3 Try plugging power adapter into another wall outlet
4 Do you have a Limerick car adapter or battery
pack to try in place of the power adapter. If pump
works you will need a new power adapter.
5 Call Limerick Customer Service.
B Not cycling, suction but 1 Remove filter with all it's tubing from pump entirely.
no release (indication of air 2 Turn pump on and rotate both knobs all the way to
leak in tubing kit or the right, clockwise.
possible pump failure) 3 Pump should be making a steady sound of pumping,
but not a cycling on and off sound.
4 Place finger over the small vacuum hole where
the filter goes.(make sure you get a good seal over
small opening in white connector for filter)
5 You should now hear the pump sound change to
cycling on and off.
6 Disconnect the tube ends from both storage containers.
7 Put filter and tubing back into filter holder on
pump. (see item 1 above)
8 Put your thumbs over both of the tube ends.
(make sure there is a tight seal)
9 You should now hear the pump sound change to
cycling on and off.
10 Unscrew the storage containers from the the storage
container caps.
11 Inside the storage container caps are the silicone gaskets,
insure that the gaskets are seated well, outer ridge on
gasket should be facing you as you place into the storage
container cap, push them down using your finger.
12 Screw the storage container back on, just snug, don't
over tighten.
13 Put the tubes back onto the storage containers caps.
14 With pump still running, place both of the breast cups
onto a hard smooth surface, such as a table top.
15 Both cups should be compressing and releasing.
16 If pump is still not working call Limerick Customer Service.