INSTALLING SURFACE MOUNT PLATES
Surface Plates are recommended for boats where accessing the underside of the floor is not possible or where frame
members prevent the proper placement of the Under Floor Plates. Surface Plates are also recommended for Fiberglass Boats
with integrated swim platforms, Houseboat Decks, Cruiser Decks, Sailboat Decks and Yachts.
Step 1
.
Determine an appropriate, and approved (
see pages 6 & 7
) mounting location which is free of obstructions for mounting
hardware and provides for safe use of your assembled diving board.
Inspect floor where board is to be mounted for construction, thickness and strength.
The following specifications must be met for approved installation:
Minimum ¾” thickness of Marine Grade Plywood or Minimum ¾” solid Fiberglass flooring
Ability to secure one linear set of screws (See lines with screws
marked with “X” in step 11) into a frame member.
Step 2
.
Place your assembled Diving Board on the deck in
your mounting location. (See Daily Assembly)
Step 3
.
With the diving platform in the lowered position and the
frame perpendicular (90°) to the deck, determine the
appropriate frame position:
Aft decks, swim platforms or other open areas:
Align the lowered platform to be positioned slightly
recessed from the gunnel or side railing. Proper
installation allows for docking or rafting without exposing the diving platform outside of
the vessels perimeter.
Over railing or side gate:
Align the platform to lay perfectly flat against the outside of the railing or gate. (Silicone
stick on buttons are provided in the mount hardware kit to prevent direct contact)
Step 4
.
Determine the appropriate ladder position by raising your diving platform and
installing the button lock pin. Move the ladder forward or backward until your
diving platform is level with the flooring surface of the boat.
Step 5.
Once the frame and ladder
positions have been re-confirmed, mark the mounting footprint and
anchor holes on the floor using the frame and ladder as a template.
10