Lilitab Counter Basic Mount
Assembly Instructions v4.0
5
ASSEMBLY INSTRUCTIONS
2.
Center the mount pole.
After you thread
the cable through the bottom, pull the other
side through the top and allow some give.
Next, be sure the mount pole is positioned
so that the center point of its rotation is
located appropriately for your installation
scenario. You can determine the center
point by aligning the openings on the rear of
the mount pole with the two screws visible
through the openings, as shown.
5.
Set rotation tension.
To disable rotation
(and/ or adjust rotation tension) tighten
the screw in the upper rear opening of
the mount pole to the desired level with
the
Silver L Key
provided.
1.
Cable routing.
Choose your method of how
you thread your charge cable that came
with your kiosk:
A: Exit out the back of the base cover.
B: Exit through the compact base plate
(no wire showing). This will require cable
routing through your substrate.
A
B
4.
Foot Cover.
Slide the foot cover down the
mount pole to cover the screws. Velcro will
hold it in place once positioned.
3.
Attach Compact Base.
Align the bottom of the
mount pole with the four (4) screw holes in
the base plate. Secure together using the
four (4) 1/4-28 x 0.375 Compact Base Screws
.
NOTE: You will need to hold the foot cover up and out
of your way while bolting. If not using the compact
base, attach to stable surface using template on page
7, and thread the cable through your substrate.
