Bachmann Europe Plc
8
N 1:160
Should it be necessary to change the bogie,
please first remove the loco body as in
Pic. 2.
Then pull the parts
P left and right as in Pic. 6
from the bogie. Afterwards pull the jumpers
PCB2 from the main board PCB1. Use a small
screwdriver to push the axle
A as per Pic. 7
through the bogie. The bogie is now free and
can be removed. Refitting is effected by follo-
wing the sequence in reverse.
Changing the bogies
Pic. 7
To do this place the model upside down on a
soft surface making sure not to damage sensitive
roof parts. You can then unclip the cover flap
C
from the bogie as shown in
Pic. 8 and remove the
wheel set with the traction tyres. Once you have
replaced the traction tyres you can refit all parts
by following the above sequence in reverse.
Please note the position of the traction tyres
before disassembly. Only correct refitting in the
right position can guarantee good traction and
driving properties.
Changing the traction tyres
Pic. 8
Please note that no liability can be assumed for any parts subsequently fitted (e.g. decoder).
LILIPUT hopes that your E44 model will give you a lot of pleasure.
C
A
PCB2
Once the loco body has been removed as shown
in
Pic. 2 you can find on the main board the inter-
face in its latest standard
NEXT18. Pic. 6 shows
the jumper configuration for DC operation.
Remove this jumper and plug in the digital deco-
der. Please make sure you follow the installation
instructions of the decoder manufacturer exactly.
For questions regarding function and installation,
please contact the decoder supplier or manufac-
turer.
Installation of a DCC Decoder
Pic. 6
PCB1
S1
NEXT18
S1
P
