INSTALLATION
X0
X1
Y0
Y1
To install HDDs, follow the following instructions:
1. Power off SATA RAID hard disk storage system.
2. Remove the top cover.
3. Fix the HDDs on the designate area with supplied screws.
4. Connect SATA cables from SATA RAID Controller to the HDDs accordingly.
5. Connect SATA power cables to SATA HDDs.
X0
X1
Y0
Y1
Y1
Y0
X1
X0
X0
X1
Y0
Y1
Y1
Y0
X1
X0
Y1
Y0
X1
X0
6. Set RAID mode jumper if applicable. See RAID mode jumper setting section.
7. Place top cover back.
8. Power on SATA RAID hard disk storage system.
9. Verify HDDs installation on LCD panel.
To verify HDDs are installed properly, please make sure all "O O O O" are shown on HDD status.
For example: HDD status is "O X O O"
The HDD at SATA port Y0 is installed but not detected.
Verify HDDs status
3
