3. Firstly, put video cable and power cable through a pipe with
1/2" PT at one end (FIG.2), and connect the cables to the
terminal block on the PCB accordingly and then screw the
pipe to the side hole (FIG.3, please make sure the connection
between the pipe and the side hole is watertight.).
Pipe is not provided.
NOTE :
6. Adjust DC iris level by turning the iris level VR.
Please refer to FIG.5.
ATTENTION: Adjust this VR with care so as not to cause
damage to the unit.
7. Put on the dome cover first. Then tighten the tamper-proof
screws (FIG.7).
4. The direction of the lens is adjustable through the adjustable
Pan/Tilt brackets and rotatable round bracket for Azimuth.
The lens can be adjusted easily by hand without using screw
driver. Please refer to FIG.4(PIH-222 /224 ) and FIG.5
(PIH-232 X/234 X).
5. An extra RCA jack for easy installation. Plug the video input
of monitor to the RCA jack and adjust focus and zoom.
After finished, unplug the RCA jack. Please refer to FIG.6.
