Liko Viking L, Service Manual

Page: 30 / 40

Service Manual Viking™ XL
mobile lift
• 3EN350401 Rev. 11 30 www.liko.com
l
www.hill-rom.com
Control Unit CBL
Parameter: Information:
TAAxT [Ah] Totally Accumulated Amphours (current x time)
TAAxTR [Ah] Totally Accumulated Amphours, resetable (current x time)
Can be reset by the manufacturer.
PAAxT [Ah] Periodically Accumulated Amphours (current x time)
Calculated continuously from the moment the lift is used until the first
service.
PAKT [Months] Periodically Accumulated Calendar time.
Calculated between services.
TADT [Hours] Totally accumulated drive time.
AAS [Starts] Accumulated starts.
The number of lifting motions counted from the moment the lift was
used the first time.
ASERV [Services] Accumulated services
Number of performed service events made using LSS or LDS.
IMED [A] Average power consumption during TADT.
Overall accumulated operating time.
ALA [Charges] Accumulatet number of started chargings.
AALA [Charges] Accumulated number of completed chargings
AOLA [Charges] Accumulated numbers of not completed charging.
Counts each disrupted charging event.
AABT [Removals] Accumulated number of battery replacements.
Counts each battery replacement where a used battery is replaced.
AEUP [Endpos. up] Accumulated number of end positions during lifting motion up.
AFSERV
[Services] Accumulated number of reset Service
Number of “Clear Service” performed manually.
AEDWN [Endpos. down] Accumulated number of end positions during lifting motion down.
SFSTAT N/A (This funktion is not in use)
IDNR Identity number of the control box.
AOLUP [Overloads] Accumulated number of stops due to overload.
PADT [Hours] Periodically accumulated operating time.
IMED 20
[A] Average current consumption. Recounted for each lifting motion (up)
which lasts more than 20 seconds.
ELT [Ah] TAAxTR limit (constant) for ELT indication.
ELTCNT [Commands] Number of ELT resets (only performed at replacement of actuator).
CLIM_1 [A] Current limit for lifting motion (up).
CLCT [ms] Maximum allowed time to override CLIM_1 before cut-off
CLIM_2 [A] Current limit for widening motion (base-width adjustment).
SINTT [Months] Indicates service intervals in calendar months.
SINTAS [Ah] AxT limit for service event. (current x time)
CYCLET [Hours] Cycle time is a constant for a medium driving cycle.
PAOLUP
[Overloads] Periodic accumulated number of stops due to overload.
CBL PARAMETER Code Key
Liko™ Diagnostic System™
(operating data) is stored in Control Unit CBL
• The information listed above is stored in the Control Unit CBL.
• Replacing the Control Unit CBL without using the LSS may cause some data loss as this data is recordable by LSS and a
computer. When data is stored in Liko™ database it can be retrieved if needed.
• Resetting the Service Interval using the LSS, LDS or Manually, will reset the Accumulated Amp-hours (PAAxT),
Accumulated Time (PAKT), Accumulated Operating Time (PADT) and Accumulated number of stops due to overload
(PAOLUP).
5.1 Control Unit CBL, Parameter Code Key