Liko Golvo 7000 Series, Service Manual

Page: 93 / 129

Assembly Instructions/Exchange
www.liko.com
Plastic housing
Part. no. 31190008
4.79.1
1. Pull the strap all the way out.
10. Roll the strap up until the red
mark reaches the plastic housing.
4. Use the pin to lock the axle
where the strap was mounted.
3. Remove the pin. Do not
let go of the springloaded wheel,
since the tension will release.
2. Hold the springloaded wheel
and release the strap by removing
the pin.
5. Push the emergency lowering
handle down and pull the strap
away.
6. Pull the rest of the strap out and
remove the plastic housing.
7. Mount the new strap through
the plastic housing with the red
mark towards the plastic housing
and then as shown above.
8. Mount the strap through the slot
in the axle and the same way back.
Note! The axle has two different
sides. Place the pin as shown to
lock the strap. Do not let go of
the springloaded wheel, since the
tension will release.
9. Push the plastic housing
on to the strap joint.
13 mm
Tools required: