SMAX MODBUS®
registers are saved as soon as you press the
ENTER
key in the keyboard or place
the cursor anywhere outside the field after setting the value.
If the
check box is not selected instead, you must press the
button to store the parameters permanently on the EEPROM after
setting.
Save parameters
This button is active only if the
check box is not selected. It allows to
activate the function meant to store the parameters permanently on the
EEPROM. It executes the whole sequence of data store commands in order to
store the parameters permanently on the EEPROM: activation of the
bit and registers setting; deactivation of the
and registers setting). While the commands are being executing, the background
of the button is coloured orange and the decimal value which results from the
binary sequence of the sixteen bits in the
updated in real time in the field under the label. For more information refer to
the
WARNING
check box to activate the autosave function. If the check
box is selected, all parameters of the Holding registers are stored automatically
and instantaneously as soon as they are set and you are never required to press
the
button: check box settings are saved as soon as the check
box is selected / deselected; the write registers are saved as soon as you press
the
ENTER
key in the keyboard or place the cursor anywhere outside the field
after setting the value. For more information please refer to the item in the
previous page.
MAN SMAX MB E 1.2
Quick reference
38 of 84
