Lika SMAX-AI1-PRG-L2, User Manual

Page: 35 / 84

SMAX MODBUS®
If the Auto save check box is not selected instead, you must press the Save
parameters
button to store the parameters permanently on the EEPROM after
setting (see on page 38).
In this section the items listed hereafter are available.
Total resolution
It allows both to set a custom resolution of the encoder (measuring step tailored
for the specific application) and to show the value that is set currently. You can
select one of the resolution options available in the drop-down menu or set a
custom value. The custom value must be expressed in hundredths of a
millimetre. See the
Resolution [0000 hex]
register on page 59. This register
can be modified only if the
Enable scaling function
option next to the
Operating parameters
item is enabled (=1).
Preset value
It allows both to set the preset value and to show the value that is set currently.
To execute the preset operation you must then press the
Execute preset button
next to the
Control word
item at the bottom of the page: it executes the whole
sequence of preset commands (activation of the
Perform counting preset
bit
and registers setting; deactivation of the
Perform counting preset
bit and
registers setting; save of parameters). Refer also to page 37. For more
information refer to the
Preset value [0001 hex]
register on page 61.
Offset value
It shows the offset value which results from the setting of the Preset value . For
more information refer to the Offset value [0002 hex] register on page 63.
Node address
It allows both to set the node address of the device and to show the value that
is set currently. For more information refer to the
Node address [0004 hex]
register on page 65.
Baud rate
It allows both to set the baud rate of the encoder's serial communication and to
show the value that is set currently. The current setting is shown in the drop-
down box. The decimal value that results from the current setting (4 in the
MAN SMAX MB E 1.2 Quick reference 35 of 84