SMRA - SSI and BiSS
NOTE
For any information on the structure of the position information word, please
refer to the section “5.2 MSB left aligned protocol” on page 19.
The operating or fault status of the device is shown visually also by the LED
installed in the side of the sensor, refer to the section “7 - Diagnostic LED” on
page 33.
For any information on errors and their solution please refer to the sections “8 -
Error and fault diagnostics” on page 34 and “10 - Troubleshooting” on page 36.
5.5 Helpful information
•
The position information increases when the ring rotates as indicated by
the arrow in Figure 1.
•
At installation always execute a zero setting operation of the position.
5.6 Recommended SSI circuit
MAN SMRA SSI_BiSS E 1.2.odt
21
www.lika.it
www.lika.biz
