LD30x
5.2 Selection and setting of parameters
5.2.1 Selecting a parameter
The
ENTER
key will scroll through the menu. The
SET
key allows to select the
corresponding item and change the setting or the numeric value. After this, the
selection can be saved by pressing the
ENTER
key again, which automatically
changes over to the next menu item.
5.2.2 Changing parameter settings
With numerical entries, at first the lowest digit will blink. When keeping the
SET
key continuously down, the highlighted digit will scroll in a continuous loop
from 0 to 9 and again from 0 to 9; and so on. After releasing the
SET
key, the
actual value will remain and the next digit will be highlighted (blink). This
procedure allows setting all digits to the desired values. After the most
significant digit has been set, the low order digit will blink again and you can
make corrections if necessary.
With signed parameters, the high order digit will scroll from “0” to "9" (positive)
followed by “-“ and "-1" (negative).
5.2.3 Saving settings
To save the actual setting, press the
ENTER
key, which will also automatically
scroll forward the menu.
NOTE
At any time the unit changes from programming mode to normal display
operation, when you keep the
ENTER
key down again for 3 seconds at least.
5.2.4 Time-out function
A “time-out” function will automatically terminate every menu level, when for a
break period of 10 seconds no key has been pressed. In this case, all changes
which have not been confirmed by
ENTER
yet would remain unconsidered.
MAN LD30x E 1.0.odt
Operating the front keys
9 of 40
