LD25x
5 Operating the front keys
For set-up and other operations the unit is fitted with three front keys which
will be denominated as follows in the next pages:
ENTER
(Input)
SET
(Setting)
CMD
(Command)
The functions of the keys are depending on the actual operating state of the
unit.
The following three operating states apply:
•
Normal display state (see section “5.1 Normal display state” on page 8)
•
Set-up state (see section “5.2 Selection and setting of parameters” on
page 9)
- Basic set-up (see section “7.1 Basic settings” on page 14)
- Operational parameters set-up (see section “7.2 Operational
parameters” on page 16)
•
Teach operation (see section “5.3 Teach operation” on page 10)
5.1 Normal display state
NOTE
You can only change over to other operation states while the unit is in the
normal display state.
Change over to
Key operation
Basic set-up
Keep
ENTER
and
SET
down simultaneously for 3 seconds
Operational
parameter set-up
Keep
ENTER
down for 3 seconds
Teach operation
Keep
CMD
down for 3 seconds
The
CMD
key is only used to execute the Teach procedure with linearisation. For
more details please refer to sections “9.1 Linearisation“ and “9.2 Manual input or
„teaching“ of the interpolation points” on page 35.
MAN LD25x E 1.0.odt
Operating the front keys
8 of 44
