ES58 • EM58 MODBUS®
Address dip switch
It shows the node address that is currently set through the DIP switch B (it is
expressed in decimal notation if the
Real values
check box is selected -1 in the
Figure- and by means of a picture). See the
register on page 79. To set the node address refer to the “4.5.2 Setting the node
address (Figure 3)“ section on page 27.
SW version
It shows the version of the software that is installed currently (as a decimal
value if the
Real values
check box is selected -512 in the Figure- and as a string
HW version
It shows the version of the hardware (PCB version) that is installed currently (as
a decimal value if the
Real values
check box is selected -256 in the Figure- and
as a string -V1.0 in the Figure). See the
page 79.
Status word
If the
Real values
check box is selected it shows the value expressed in decimal
notation (257 in the Figure) that can be read currently next to the
register, refer to page 80. If there are active alarms, the
Alarm
message appears on the right while the position and number of revolutions
values above disappear. A further yellow message shows whether the scaling
function and the counting direction function are enabled.
Alarm register
If the
Real values
check box is selected it shows the value expressed in decimal
notation (1 in the Figure) that can be read currently next to the
register, refer to page 76. If there are active alarms, the specific
alarm message appears on the right (e.g.
DM error
in the Figure) while the
position and number of revolutions values above disappear.
Machine data not valid
If the
Real values
check box is selected it shows the value expressed in decimal
notation (2 in the Figure) that can be read currently next to the
parameters list [0004-0005 hex]
register, refer to page 77. If a wrong
parameter has been set, it is stated on the right (
Counts per rev
in the Figure)
MAN ESx58x_EMx58x MB E 1.3
Quick reference
38 of 92
