KEY FUNCTIONS
1. INDICATOR
The LED indicator shows the handset is transmitting. It will blink blue
when an ON command is sent
2. GARDEN ON / OFF (LS30032FOB model only)
Press to switch all the garden lighting on or off.
3.
AREA ON / OFF
Press keys 1 to 4 once to switch an area on (that has been
previously stored). Press keys 1 to 4 again to switch an Area off.
Note, the first press switches an area on, the second switches it off (toggle).
4. COLOUR
CONROL
(only possible where suitable lighting is installed)
To change colour just press & hold an Area key.
MODEL
MODEL
LS30034FOB
LS30034FOB
ISSUE 1.3
COPYRIGHT © PM INTERNATIONAL LTD 2012
‘SYSTEM’ CODE
Light Symphony controllers use a ’System Code’ to prevent interference with
neighbouring systems. Lighting controllers will only respond if their System Code
matches the code set in the keyfob. The keyfob is factory preset to System Code 1.
It is highly advisable to change the System Code for each new project to reduce the
chance of interfering with neighbouring systems.
To select a new System Code from 1 to 32, press and hold the top two buttons together
for a few seconds, until the blue light stays on. Next click the top-left button to set the
new code, where each click is counted e.g. press 4 times to set System Code = 4.
After 5 seconds of not pressing any keys, the blue LED will blink the code back, to
confirm the value that’s been stored. e.g. 4 flashes confirms System Code = 4.
The keyfob’s System Code is automatically adopted by the lighting controllers
(receivers) when a lighting Area (Zone) is programmed.
NOTE: When commissioning a new system always set the Keyfob (or remote
control’s) System Code first. This ensures lighting controllers have a chance to learn
the code during commissioning.
The Keyfob will store the System Code permanently, even if the battery is removed or
runs down.
1
2
3
4
OFF
ON
1
2
1
2
3
4
)
LED
1. Press & HOLD the top two
buttons
together until blue LED
lights
)
2. Click top-left button 1- 32
times to set the new System Code.
