44
1. Overview
2. Installation
3. Setup & Use
4. T
roubleshooting
5. W
arranty &
Specifications
45
1. Overview
2. Installation
3. Setup & Use
4. T
roubleshooting
5. W
arranty &
Specifications
Step 4:
Connecting and Routing Speaker
Wire
a) Locate the 50-foot length of
plenum rated wire included with
the speaker and the green euro-
block style connector.
b) Connect one end of the speaker
wire to the euro-block connector
(see figure 6).
i. Insert the positive conductor
(RED or WHITE in color) into the
left side of the connector and
use a screwdriver to tighten.
ii. Insert the negative conductor
(BLACK) into the right side of
the connector and tighten.
c) Insert the euro-block connector
into the jack on the back of the
MCQ as shown in figure 6.
d) Route the speaker wire above the
ceiling tiles and back down to the
receiver/amplifier. Wire should be
secured and tied off overhead as
required by local building codes.
Wire raceway should be used
on walls to properly conceal and
protect the wire.
Step 5:
Return to installation section of the
product manual to continue system
installation.
14. SPEAKER CONFIGURATION
CONT’D
15. IR SENSOR/RECEIVER (ISR) INSTALLATION
Next, find a suitable location for the ISR. Poor location will cause substandard
performance of the CAT AV Classroom Audio System. The ISR should be as high
as possible in the room – the ceiling is the best location, centered along the
longest wall in the room. When possible, use a conduit to protect the wires (not
included). Poor choices for placement are corners, on walls at heights lower than
7 feet (2 meters), or in places where the line of sight from the ISR to the receiver
is or could be obstructed.
Good placement
Conduit is Recommended
Best placement
Avoid!
Summary of Contents for AC-CAVWC
Page 1: ......
