background image

 

PLEASE READ BEFORE CONNECTING FIREFLY! 

Congratulations on your purchase of FireFly, the world’s most sophisticated lightning 

simulator. For safe operation of your equipment, please pay careful attention to the 

following caution statements. 

 

• Do not operate or store in wet locations. Operation in wet locations is hazardous 

and water damage is not covered by your warranty. 

• Use only with properly grounded 15 or 20 amp, 120 volt outlets. Never use a 

ground adapter to avoid grounding this unit. As with most electronic devices, if 

using outdoors, a GFCI (ground fault circuit interrupter) outlet or breaker must be 

used for your safety. 

• FireFly is equipped with an extra long power cord for your convenience. Avoid 

using an extension cord if possible. If you must use an extension cord, it should be 

a heavy-duty appliance type cord. 

• Always use an adequate size grounded cord for connecting your lights sources. If 

in doubt about the appropriate size, contact a licensed electrician. 

• While connecting FireFly’s power cord to a surge suppressor can protect your 

investment from damage due to transient spikes or actual lightning damage, you 

must NEVER connect surge protectors to FireFly’s outlets as serious damage to the 

unit could occur. 

• Replace fuse only with the type and size specified in the manual or on the pack 

panel of device. Oversized fuses may damage unit and/or create a fire hazard. 

• Do not block air vents on the side (FF-

501/

5

1

1) or rear (FF-201/101) of FireFly. 

•  Use  only  with  approved  light  sources.  Never  exceed  the  maximum  rating  per 

channel or the total rating of the system. Compact fluorescent lamps are approved 

only for use on the dimmer channel. Using strobes other than those recommended 

and sold by Lights Alive is at your own risk. Lights Alive will assume no liability 

for damage caused by the use of unapproved strobes.

 

• FireFly is designed to be connected to line-level or earphone audio jacks. Do not 

connect directly to speaker terminals without the use of an approved attenuating 

adapter, available from Lights Alive. 

(2)

Summary of Contents for FireFly FF-511









Reviews: