Page
2
of
6
FXLD68FP2I LED FIXTURE
Version 0.1
OWNERS MANUAL
06/20/2013
www.lightronics.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
If your console uses a 5 pin connector you can make up
an adapter cable to accommodate this. The table below
shows the pin assignments for BOTH the 3 pin and 5
pin connectors.
DMX TERMINATION
A DMX chain should be terminated at the last
receiving device on the chain. This is done by
installing a commonly available 1/4 Watt, 120 Ohm
resistor across the DATA - and DATA + wires at the
last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.
OPERATION
A control panel on one side of the unit is used to set the
operating options. It consists of an LED display and
four buttons
(MENU, UP, DOWN, and ENTER)
Push
MENU
to access the operating options. Then use
UP
and
DOWN
to scroll through the available choices.
When you reach the option you want to set or change -
push
ENTER
.
Now you can view the current setting
for the option and/or change it. Push
ENTER
to save
your changes and activate the option. See the "MENU
NAVIGATION" diagram for additional details.
There are 7 operation modes: DMX, Warm White
Level, Cool White Level, Strobe, Fade, Auto
Sequence, and Auto Run.
DMX OPERATION
Use the
Addr
menu to set the starting address of the
unit. You can set the starting address of the unit with
the
UP
and
DOWN
buttons.
For DMX operation the FXLD68FP2I fixture can be
configured as a 1 channel, 2 channel, 3 channel, 4
channel, or 5 channel unit.
Set the
CH - -
menu to
P001
(1 channel),
A001
(2
channel),
F001
(3 channel),
D001
(4 channel), or
H001
(5 channel).
Detailed information on DMX channel operation is
given in the tables
DMX VALUES AND FUNCTIONS
.
MANUAL OPERATION
For manual operation the warm white and cool white te
LED intensity levels may be independently set. Use
the
uL - -, EL - -,
menus to set the levels. The range
is from 00 to 100. 00 is OFF.
STROBE MODE (
FLAS
)
The Strobe mode causes the unit to flash all led's. The
speed is user controllable by using the
FLAS
menu.
The speed range is 1 - 100. 100 is fastest.
AUTO FADE
(
FAdE
)
The Auto Fade mode cycles smoothly through a
sequence of seven colors. Use the
FADE
menu to set
the speed and activate the option. The range is from 0
to 100. 100 is fastest.
AUTO SEQUENCE (
ASC -
)
The AUTO SEQUENCE mode switches continuously
through a sequence of colors. Use the
ASC -
menu to
set the sequence speed. The range is from 1 to 100.
100 is fastest.
AUTO RUN (
Auto
)
The unit can operate using 100 preset programs.
Programs 0 thru 49 are a variety of colors and patterns.
Programs 50 thru 100 are similar but are sound synced
to music base notes.
Use the
Auto
menu to select and activate a program.
PIN #
SIGNAL NAME
1 DMX
COMMON
2
DMX DATA -
3
DMX DATA +
4 NOT
USED
5 NOT
USED
MENU UP
DOWN
ENTER
CONTROL PANEL
